User Manual
PAGE :
DOCUMENT No :
REG. DATE : 2020.05.21
MODEL NAME:
ETWCFMBC01(LGIT)
LGSBWAC95(LGE)
REV. DATE : 2020.05.21
REV.NO : V1.0
-
Copyright
ⓒ
. 2020. All Rights Reserved.
11 / 9
Regulatory notice to host manufacturer according to KDB 996369 D03 OEM Manual v01>
List of applicable FCC rules
This module has been granted modular approval as below listed FCC rule parts.
-FCC Rule parts 15C(15.247)
Summarize the specific operational use conditions
-The OEM integrator should use equivalent antennas which is the same type and equal or less gain then an antenna
listed in 2.7 in this instruction manual.
RF exposure considerations
The module has been certified for integration into products only by OEM integrators under the following condition:
-The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is maintained between
the radiator (antenna) and all persons at all times.
-The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures.
-Mobile use
As long as the three conditions above are met, further transmitter testing will not be required.
OEM integrators should provide the minimum separation distance to end users in their end-product manuals.
Antennas list
This module is certified with the following integrated antenna.
-Type: Metal antenna (Internal Antenna)
- Max. peak Antenna gain
Any new antenna type, higher gain than listed antenna should be met the requirements of FCC rule 15.203 and
2.1043 as permissive change procedure.
Label and compliance information
End Product Labeling
The module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC Certification Number
are not visible when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. In that case, the final end product must
be labeled in a visible area with the following:
“Contains FCC ID: BEJ
-WL1NB6V2
”
“Contains IC: 2703H-
WL1NB6V2
”
Information on test modes and additional testing requirements
-OEM integrator is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, additional transmitter in
the host, etc.).
Additional testing, Part 15 Subpart B disclaimer
-The final host product also requires Part 15 subpart B compliance testing with the modular transmitter installed to be
properly authorized for operation as a Part 15 digital device.
Frequency Band
Ant 1
Ant 2
1.47
dBi
1.33
dBi
UNII-1 (5
155-5200
)
1.39
dBi
1.45
dBi
UNII-3 (5
730-5845
)
