background image

Please read and understand this entire manual before attempting to assemble, operate or install the product.

ASSEMBLY INSTRUCTIONS

REPLACING BATTERY

Lowes.com/portfolio

3

2

Lowes.com/portfolio

SAFETY INFORMATION

!

PREPARATION

Do not open, short circuit, or damage batteries as injury may occur.

!

WARNING

CAUTION/PRECAUCIÓN

Do not dispose of batteries in the regular trash, municipal waste stream or by fire as batteries may leak or explode.

Preserve our environment by recycling batteries or disposing of them in accordance with local, state, and federal

regulations.

Do not use alkaline or standard(carbon-zinc) batteries; use rechargeable batteries only.

Before

 

installing the 

product, 

make sure all parts are present. Compare parts with package contents list. If

 

any part 

is missing or damaged, do not attempt to assemble, install or operate the product.

Estimated Assembly Time: 5-10 minutes

Helpful Tools (not included): 

Phillips head 

Screwdriver

  

1. 

A

E

1

A

F

2

A

B

C

D

1

Remove four screws from back of solar panel with screwdriver 

(not included). Gently separate the top and bottom of the solar 

panel, being very careful not to 

disconnect or remove any wires or 

other connections inside the 

compartment.

1.

Replace the old battery with a new 3.7-volt, 2000 mAh,18650 

lithium battery. Replace top to bottom of solar panel and 

retighten screws to secure.

FOR FIRST TIME USE:

Allow the light to run 8-12 charging 

and discharging cycles to reach 

battery's maximum capacity.

2.

Attach the spot light (A) to ground 

stake (B) using wing nut (C) by 

inserting screw (D) into the hole on 

(A&B). Align the holes on (A&B), 

tighten the wing nut (C) until secure. 

To adjust the spot light head, loosen 

wing nut (C) and position the light 

head. When desired position is 

achieved, tighten the wing nut (C) 

until secure.

2. Solar panel can be adjusted

;

either 

tilt 

up 

or

 down,

or rotate horizontally to receive

the maximum amount of sunlight.

No need to loosen screws.

3. 

A

3

The power switch, located on

 

the back of the solar panel, has

 

2 settings-ON and OFF. 

Push the switch to

“ON” position to allow the spot

 

light (A) to automatically turn on

 

at dusk.

If you do not intend to use the

 

spot light (A) for an extended

 

period of time, be sure to move

 

the 

switch to 

the 

“OFF”

 position

.

2

Adjust

Rotate

Отзывы: