4
PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or damaged, do
not attempt to assemble, install or operate the product.
Estimated Assembly Time: 30 minutes.
Tools Required for Assembly (not included): Concrete, Flathead Screwdriver, Phillips Screwdriver,
Pliers, Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper, 1/2 in. Wrench.
ASSEMBLY INSTRUCTIONS
1.
Excavate an area in the ground deep enough to enclose the
height of the anchor bolts (BB) and wide enough for the
mounting bracket (AA). Route the electrical wire from the
power supply underground and out through the middle of the
installation area. Screw the anchor bolts (BB) into the
mounting bracket (AA). Fill hole with concrete (not included)
and insert the assembly before the concrete dries.
Note:
The mounting bracket (AA) should be at ground level,
with the anchor bolts (BB) 1.9 in. above the ground.
The
approximate length of supply wires that should be out of the
concrete is 6-8 inches.
2. Secure the
fixture (E) to the top pole (A), securing with the
preassembled set screws. Tighten with 3 mm wrench (FF)
.
3.
Remove the preassembled set screw from the middle pole
(A) and
screw the middle pole (A) clockwise onto the bottom
pole (B). Re-insert set screw, then tighten with wrench (FF)
.
Hardware Used
Wrench
x 1
FF
3
Hardware Used
Wrench
x 1
FF
2
FF
FF
B
A
A
E
Hardware Used
Mounting Bracket
x 1
Anchor Bolt
x 3
AA
BB
