6 Maintenance
6.1 Replace or install batteries
To replace the battery (refer to
Figure: Replace batteries
) follow the
procedure that follows:
A.
Remove the battery cover using a finger nail or small screwdriver.
B.
Unclip the battery holder from the clip.
C.
Remove the old batteries and replace with 4 new ones.
D.
Reconnect the battery holder to the Phoenix Mobilis and make sure
that the polarity is correct.
The battery holder can then be placed back in the instrument. Make sure
that the wires are not trapped when reinstalling the battery cover. It is
recommended that after battery replacement, the Phoenix Mobilis is
programmed with the correct battery selection (alkaline or nickel metal
hydride) as described in
Phoenix Mobilis keypad
on page 15, this makes
sure that the battery status indicator can correctly identify the remaining
capacity of the battery.
Figure 9. Replace batteries
A.
Battery cover removal
B.
Unclip the battery holder
C.
Replacement with of battery
D.
Polarity check
A.
Battery cover removal
B.
Unclip the battery holder
C.
Replacement with of battery
D.
Polarity check
6.2 Calibration
Calibration should only be attempted by qualified service engineers. We offer
a calibration facility for Phoenix Mobilis instruments. Contact us for more
details.
The Phoenix Mobilis is supplied with two calibration settings, factory and
custom. The factory calibration setting cannot be changed. The custom
calibration allows the user to calibrate the Phoenix Mobilis at the local
atmospheric pressure which may offer an improvement over the factory
calibration.
21
300956073_C0 - 03/2021 - © Leybold
Maintenance
