LEYBOLD DISPLAY THREE, Инструкция по эксплуатации

Страница: 24 / 40

24
GA09037_002_C0
– 09/2016
6.4.3 Pushbutton Functions
6.4.3.1 Measurement Channel Selection

Press the pushbutton CH.
The instrument selects the next measurement channel. The display of Para for the
selected measurement channel will flash for 10 seconds.
Figure 13
–
Operating the pushbutton CHANNEL
6.4.3.2 Parameter Mode Selection

Press the pushbutton PARA and keep it depressed for approximately 2 seconds. The
instrument will change to the parameter mode (

Chapter 6.5 Parameter Mode,
page 26).
When not operating any pushbutton within 10 seconds, the instrument will then
automatically return to the measurement mode.
Figure 14
–
Operating the pushbutton PARA
6.4.3.3 Switching on the High Vacuum Measurement Circuit
The high vacuum measurement circuit of the following sensors can be switched on
manually: PENNINGVAC sensors PTR81N, PTR225, PTR225N, PTR225S, PTR225SN,
PTR237 and PTR237N. For this the sensor control must be set to HAnd (

Chapter 7.2.5
Sensor Switch-on Type (S-on), page 31).

Keep the key marked CH pressed so as to select the respective measurement channel.

Keep the key marked UP pressed for approximately two seconds.
The sensor for the selected measurement channel is switched on. Either the
measured value or a status message will be displayed.

Table 6, page 23.
Figure 15
–
Operating the pushbutton UP