Planar LookThru Transparent OLED Display User Manual
020-1380-00B
Page | 40
Navigating Through the Menus
24.2 Power Submenu
Auto Power On
•
Set whether the system will automatically leave standby mode after AC power is
applied
•
Options:
On, Off;
Default:
Off
Power Saving Mode
•
Set the action to take if there is no signal detected after the period of time selected
by the Power Saving Delay setting:
•
Disabled:
The display will remain on even if no signal is present.
•
Low Power:
The display will enter standby mode if no signal is detected after the
specified period of time.
•
Wake on Signal:
The display will enter a reduced power mode if no signal is
detected after the specified period of time. When in this state, the display will turn
on when a signal is detected or when any key is pressed on the keypad or IR
remote.
Power Saving Delay
•
Set the number of minutes to delay before initiating the power saving mode action (if
any)
•
Options:
1 Minute, 5 Minutes, 15 Minutes, 30 Minutes, 60 Minutes;
Default:
5
minutes
Power On Delay
•
Postpones startup by the set amount
•
Range:
0 to 10 seconds in 0.1 second increments
