Planar LookThru Transparent OLED Display User Manual
020-1380-00B
Page | 12
Tour of the Planar LookThru Transparent OLED Product Family
removed for a fixed mounting installation. No fewer than three of the primary mounting
holes are recommended to be used for any installation. The Display Chassis is the part of
the display to use as a primary handhold during transport and mounting.
There are five secondary M6 mounting points on the underside of the electronic box.
These should only be used together with the primary mounting points on the Display
Chassis, but never by themselves. A counter weight is attached to the underside of the
electronic box in the
Planar
LookThru LO552. The counter weight also serves to create
an acceptable open space for ventilation on the underside of the display. Like the leveling
feet, it should be removed for a fixed mount installation, but provisions must be made for
the proper 5 mm inch spacing.
Note that the corners of the Display Chassis and the right side (viewed from the front) of
the electronic box are chamfered at a 45
º
angle, allowing a corner or right-angle
installation of Planar LookThru LO552 displays. This is a feature found in all the LO552
family of displays. The bottom view of a Planar LookThru LO552 in the figure below
illustrates the corner chamfers. The leveling feet and counterweight are also shown.
The backside of the electronic box also contains the controlling I/O for the display. This is
shown in the figure below. The power switch and power cord receptacle are centered on
the backside.
The keypad is described in detail in the “OSD Keypad” section on page 23. There are
four HDMI connectors consisting of two HDMI 2.0 compliant and two HDMI 1.4 compliant
inputs. Additionally, there is a DisplayPort 1.2 input and a corresponding DisplayPort
output. The RS-232 and LAN connectors are found on the right side of the electronic box
along with the jack for the remote sensor as well as USB-A and USB-B ports.
