Lexmark XM1135, Руководство по обслуживанию

Страница: 99 / 510

Error code Description Action
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.23 Laser servo never started due to potential conflict
with the transfer servo. Go to “Sensor (input) image jam service check”
on page 102 .
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image finished to start new image). Go to “Sensor (input) image jam service check”
on page 102 .
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle. Go to “Sensor (input) image jam service check”
on page 102 .
200.30 Invalid printhead NVRAM. Go to “Sensor (input) image jam service check”
on page 102 .
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.32 Detected cover switch bounce. Go to “Sensor (input) early/late arriving service
check” on page 100 .
Printhead lost HSYNCs due to a glitch with the
laser safety interlock, for example, bouncy cover
switch. Go to “Laser scanning unit (LSU) service check”
on page 152 .
200.33 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.38 Interpage servo gap smaller than expected for
galvo offset target evaluation. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring tray 1 source empty. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor. Go to “Sensor (input) early/late arriving service
check” on page 100 .
200.45 During warm up flush, sheet detected too long
over input sensor. Go to “Sensor (input) early/late arriving service
check” on page 100 .
7015
Diagnostics and troubleshooting
99