Lexmark XM1135, Руководство по обслуживанию

Страница: 256 / 510

•
Put the ESD wrist strap on your wrist. Connect the wrist band to the system ground point. This discharges
any static electricity in your body to the machine.
•
Hold the ESD-sensitive part by its edge connector shroud (cover); do not touch its pins. If you are removing
a pluggable module, use the correct tool.
•
Do not place the ESD-sensitive part on the machine cover or on a metal table; if you need to put down the
ESD-sensitive part for any reason, first put it into its special bag.
•
Machine covers and metal tables are electrical grounds. They increase the risk of damage, because they
make a discharge path from your body through the ESD-sensitive part. (Large metal objects can be discharge
paths without being grounded.)
•
Prevent ESD-sensitive parts from being accidentally touched by other personnel. Install machine covers
when you are not working on the machine, and do not put unprotected ESD-sensitive parts on a table.
•
If possible, keep all ESD-sensitive parts in a grounded metal cabinet (case).
•
Be extra careful while working with ESD-sensitive parts when cold-weather heating is used, because low
humidity increases static electricity.
Controller board/control panel replacement
This procedure should be followed only if both the controller board and the control panel fail. If you need to
replace only one of the FRUs, follow the startup procedure described in the FRU’s removal procedure.
CAUTION—POTENTIAL INJURY: The lithium battery in this product is not intended to be replaced.
There is a danger of explosion if a lithium battery is incorrectly replaced. Do not recharge, disassemble,
or incinerate a lithium battery. Discard used lithium batteries according to the manufacturer's instructions
and local regulations.
Warning—Potential Damage: If the control panel and the controller board are being replaced at the same
time, replace the parts in this order to avoid damage to the machine.
1
Replace the controller board first.
Note: Do not replace the new control panel and controller board in the machine at the same time.
2
After installing the new controller board, and before installing the new control panel, start the printer into
diagnostics mode.
3
After the printer has completed startup, turn off the printer and replace the control panel.
Note: If the control panel display has failed, the printers’ startup cycle is complete when the driver motor
and fans shut down, and the machine is quiet.
4
After installing the new control panel, start the printer into diagnostics mode, and allow the printer to go
through a complete startup cycle and the display to go to Ready.
5
If the problems persist, leave the new control panel in the machine, place the old controller board back in
the machine, and start it up. After the machine startup, shut down the machine, and install the new controller
board. After installing the new controller board, restart the machine, and let it go through the startup cycle.
After this procedure is completed successfully, there is no need to adjust any settings.
If the above procedure fails, you must contact the technical support center for further instructions.
7015
Parts removal
256