Lexmark M5170, Руководство по обслуживанию

Страница: 324 / 949

REGISTRATION
These settings adjust the margins of the black plane.
To set the Registration:
1
Print a Quick test page.
a
From the Diagnostics menu, navigate to:
REGISTRATION > Quick Test
b
Retain this page to determine the changes you need to make to the margin settings. The alignment diamonds
in the margins should touch the margins of the page.
The Quick test page contains the following information:
•
Printer registration settings
•
Code levels
• Alignment diamonds at the top, bottom, and each side
• Horizontal lines for skew adjustment
• General printer information, including current page count, installed memory, processor speed, serial
number, engine ID, and controller board ID
2
Change the value of any of the margin settings.
Top Margin -25 to +25 Increasing the value moves the image down the page. Always adjust the
top before the bottom margin.
Bottom Margin -20 to +20 Increasing the value moves the image toward the top of the page.
Left Margin
‑
25 to +25 Increasing the value moves the image toward the right margin. Always
adjust the left before the right margin.
Right Margin -15 to +15 Increasing the value moves the image toward the right of the page.
PRINT TESTS
The Print Test determines whether the printer can print on media from any of the paper input sources. Each of the
installed sources is available within the Print Tests menu.
The content of the test page varies depending on the media in the selected input source:
• If the selected source contains paper, then a page similar to the Quick test page is printed, but without the print
registration diamonds.
• If the selected source contains envelopes, then an envelope print test pattern is printed. This pattern contains only
text, which consists of continuous prints of each character in the selected symbol set. If Continuous is selected,
then the envelope print test pattern is printed on the first envelope; the rest are blank.
The Print Test page always prints single-sided, regardless of the duplex setting or the presence of the duplex option.
To run the Print Test:
1
From the Diagnostics menu, navigate to PRINT TESTS .
2
Select the paper source.
3
Select any of the following:
•
Single —Prints a single Print test page (No buttons are active while the Print Test Page is printing.)
•
Continuous —Continuously prints the Print test pages until X is pressed
4063
Service menus
324