3
From the menu that appears, do either of the following:
•
For Windows 7 or later, select
Printer properties
.
•
For earlier versions, select
Properties
.
4
Click the
Configuration
tab.
5
Do either of the following:
•
Click
Update Now
‑
Ask Printer
.
•
Under Configuration Options, manually add any installed hardware options.
6
Click
Apply
.
For Macintosh users
1
From the Apple menu, navigate to either of the following:
•
System Preferences
>
Print & Scan
> select your printer >
Options & Supplies
>
Driver
•
System Preferences
>
Print & Fax
> select your printer >
Options & Supplies
>
Driver
2
Add any installed hardware options, and then click
OK
.
Networking
Notes:
•
Purchase a MarkNet
TM
N8352 wireless network adapter first before setting up the printer on a wireless network.
For information on installing the wireless network adapter, see the instruction sheet that came with the
adapter.
•
A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi
Protected Access (WPA), WPA2, and 802.1X - RADIUS are types of security used on a network.
Preparing to set up the printer on an Ethernet network
To configure your printer to connect to an Ethernet network, organize the following information before you begin:
Note:
If your network automatically assigns IP addresses to computers and printers, continue on to installing the
printer.
•
A valid, unique IP address for the printer to use on the network
•
The network gateway
•
The network mask
•
A nickname for the printer (optional)
Note:
A printer nickname can make it easier for you to identify your printer on the network. You can choose to
use the default printer nickname, or assign a name that is easier for you to remember.
You will need an Ethernet cable to connect the printer to the network and an available port where the printer can
physically connect to the network. Use a new network cable when possible to avoid potential problems caused by a
damaged cable.
Additional printer setup
29
