Lexmark C520 Series, Руководство по обслуживанию

Страница: 72 / 259

2-14
Service Manual
5022- xxx
63 xx Unformatted disk • Press until
Continue
appears, and then press to clear the
message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
64 xx Unsupported disk format • Press until
Continue
appears, and then press to clear the
message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
80 xx Fuser life warning • Press until
Continue
appears, and then press to clear the
message and continue printing.
• Order a replacement fuser. When print quality is reduced, install the new
fuser using the instruction sheet that comes with the replacement fuser.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
80 xx Replace fuser • Replace the fuser.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
82 Waste toner box nearly
full • Press until
Continue
appears, and then press to clear the
message and continue printing.
• If printing continues, order a replacement waste toner box immediately.
• If problem persists, open front access door and check bump aligner shaft
for binding. Clear binding if possible. If not possible, contact next level of
service.
82 Replace waste toner box • Replace the waste toner box using the instruction sheet that comes with
the replacement waste toner box.
• Ensure that there is not interference between the waste toner box and
printer.
• If replacing waste toner box does not fix the problem, open front access
door and check bump aligner shaft for binding. Clear binding if possible. If
not possible, contact next level of service.
• If the waste toner box replacement and bump aligner binding fix does not
solve the problem, replace system card. Go to “System card removal”
on page 4-47 .
82 Waste toner box missing • Insert the waste toner box.
• Inspect top cover camshaft assembly for proper operation. When top
access cover is closed, printer should mechanically interlock.
• Check JBUMP1 connection/cable connected to system card for defects
and proper connection. If cable wiring or cable connection is defective,
replace bump aligner motor. Go to
“Bump aligner motor removal” on
page 4-45 . Replace system card, if JBUMP1 connector is damaged on
system card. Go to “System card removal” on page 4-47 .
• Check bump aligner shaft and mechanical system for binds.
• Replace bump aligner motor. Go to
“Bump aligner motor removal” on
page 4-45 .
• If problem persists, replace system card. Go to “System card removal”
on page 4-47 .
Error
code Sub
code
Primary message Action