Lexmark C520 Series, Руководство по обслуживанию

Страница: 69 / 259

Diagnostic information
2-11
5022- xxx
34 xx Short Paper • Press until
Continue
appears, and then press to clear the
message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure media is properly fitted.
• Make sure the print job is requesting the correct size of media.
• Adjust the Paper Size setting for the media size being used.
If MP Feeder Size is set to Universal, make sure the media is large
enough for the formatted data.
• Cancel the current job. Replace paper pick mechanism. Go to “Paper
pick mechanism assembly removal” on page 4-30 .
• If problem still exists, replace system card. Go to “System card
removal” on page 4-47 .
34 xx Incorrect Media • Load the appropriate media in the selected source.
• Press
until
Continue
appears, and then press to clear the
message and print the job using a different paper source.
• POR printer to recalibrate transparency sensor.
• Ensure transparency sensor is mounted correctly in paper pick
mechanism. If not, snap into place.
• Replace paper pick mechanism. Go to “Paper pick mechanism
assembly removal” on page 4-30 .
• If problem still exists, replace system card. Go to “System card
removal” on page 4-47 .
35 xx Insufficient memory to
support Resource Save
feature • Press until
Continue
appears, and then press to disable
Resource Save and continue printing.
• To enable Resource Save after receiving this message:
- Make sure the link buffers are set to Auto, then exit the menus to
activate the link buffer changes.
- When
Ready
is displayed, enable Resource Save.
• Install additional memory.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
37 xx Insufficient memory to
collate job • Press until
Continue
appears, and then press to print the
portion of the job already stored and begin collating the rest of the job.
• Cancel the current job.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
37 xx Insufficient memory for
Flash Memory
Defragment operation • Press until
Continue
appears, and then press to stop the
defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
37 xx Insufficient memory,
some held jobs were
deleted • The printer deleted some held jobs in order to process current jobs.
• Press
until
Continue
appears, and then press to clear the
message.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
Error
code Sub
code
Primary message Action