Lexmark 4227-100, Руководство по обслуживанию

Страница: 55 / 134

Diagnostic Information 2-35
4227-100
Paper Feed Problems
FRU Action
1 Tractor 2 On the printer, make sure the Tractor 2 driving
gear turns freely when the white sub slider cam
is not pressed. Be sure the driving gear does
not move when the sub slider cam behind the
gear is pressed.
Remove Tractor 2 from the printer and remove
all paper. With the paper select lever in the
continuous forms position, press LineFeed;
the tractors should rotate.
Press the sub slider cam below the ASF/
Tractor 2 drive gear and press LineFeed again;
the tractors should not rotate but the drive gear
should.
Check the condition of the pin feed belts. With
the power off, make sure the slider does not
bind.
Verify:
• When the slider is to the rear, the white
gear drives the tractors;
• When the slider is to the front the gear
and tractors are not connected.
Remove the Tractor 2 cover and reinstall
Tractor 2 in the printer (if necessary remove the
printer covers also). Note that the small idler
gear just below the slider is held in place by the
cover; with the cover removed it will tend to
move off the stud. Also note that when
operating the Tractor 2 with the printer cover
removed, the Tractor 2 sensor must be held
open.
Turn the printer on and look for mechanical
problems.
For information on the Tractor 2 cable
connectors, see
“Tractor 2 Cable Connectors”
on page 5-15 .