50
Lexmark X850, X852e, X854e
Use only materials recommended for use with laser printers.
To prevent specialty media sheets from sticking together, remove each sheet from the output bin as it is printed.
When printing on labels:
•
Set the Paper Type to Labels from the printer driver.
•
Use standard size products (either A4 or Letter).
•
Do
not
use label sheets with a slick backing material.
•
Do
not
print within 1 mm (0.040 in.) of the die cut.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Partial
sheets will also contaminate your printer and your cartridge with adhesive, and could void your printer and
cartridge warranties.
•
Use labels that can withstand temperatures of 180°C (356°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.
•
Verify that your label adhesive material can tolerate a fusing temperature of 180°C (356°F) for 0.1 second.
•
Use labels that can withstand pressure of 25 pounds per square inch (psi).
•
Do
not
print within 1 mm (0.040 in.) of the edge of the label, of the perforations, or between die-cuts of the label.
•
Do
not
use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.040 in.) away from edges. Adhesive material will contaminate your printer and could void your
warranty.
•
If zone coating of the adhesive is not possible, a 3 mm (0.125 in.) strip should be removed on the leading and
driver edge, and a non-oozing adhesive should be used.
•
Remove a 3 mm (0.125 in.) strip from the leading edge to prevent labels from peeling inside the printer.
•
Portrait orientation is preferred, especially when printing bar codes.
•
Do
not
use labels that have exposed adhesive.
•
Do
not
use labels that are separating from the backing sheet or are wrinkled, bubbled, or otherwise damaged.
•
Do
not
load a sheet of labels through the machine more than once.
•
Load labels into the manual bypass feeder with the recommended print side faceup and the top edge going in first.
When printing on card stock:
•
Set the Paper Type to Card Stock from the printer driver.
•
Do
not
use preprinted card stock manufactured with chemicals that may contaminate the printer. Preprinting
introduces semi-liquid and volatile components into the printer.
•
Do
not
use card stock that is creased. It may cause paper jams.
•
We recommend the use of grain short card stock.
•
Load card stock into the manual bypass feeder with the recommended print side faceup and the top edge going in
first.
Содержание 22L0176 - C 770dn Color Laser Printer
Страница 145: ...Index 145 Z zone coating adhesives 16 integrated forms 21 label design 17 ...
Страница 146: ...www lexmark com ...
