63D0001
7
REMOVING THE STOVE FROM THE PALLET AND ATTACHING THE LEGS ON THE SSW30(F/S)TAL
Caution: Stove is extremely heavy. You will need help installing the legs and moving your stove to its fi nal
location.
Please note: The fi berboard baffl e is secured with two screws for shipping purposes only. These screws are
located behind the rear tube and may be removed prior to use, if so desired.
The legs are packed inside the stove with bolts for assembling legs to the stove.
Useful note: If you misplace the bolts in the leg pack,
the bolts used to hold the shipping bracket to the stove can be used to hold the legs in place.
Tools required: 7/16
"
& 9/16
"
wrench or socket.
1) Remove the foam leg pack from inside your stove. The pack should contain 4 legs and 8 bolts.
2) To begin the leg installation remove the bolts from the hold down brackets from the pallet
only
. This is so you will be able to
move the stove to the edge of the pallet and install the legs one at a time. (9/16
"
wrench or socket.)
Figure 1
3) Slide the stove so that a rear corner of the stove is extended past the edge of the pallet just enough to install rear leg.
Figure
2
4) Remove both bolts from the rear leg location of the hold down bracket and
one
of the bolts from the front leg location of the
same hold down bracket. (7/16
"
wrench or socket.)
5) Swing hold down bracket out from stove just far enough to install rear leg.
Figure 3
6) Use the bolts provided to install the rear leg. (7/16
"
wrench or socket.)
. Figure 4
UNPACKING AND ATTACHING LEGS
Figure 2
Figure 1
Figure 3
Figure 4
