Lexington Forge ASHTON AI42DV, Инструкция по установке и эксплуатации

Страница: 30 / 40

30
48D0139 48D0139
31
���
CLEANING
AND
MAINTENANCE
Clean the ceramic glass periodically. Condensation will some-
times form on the glass during a cold startup. This is normal for
all gas fireplaces and inserts. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing
of the appliance can also leave a slight film on the glass. This
is a temporary problem.
Your should clean the glass after the first two weeks of use. After that, you should clean the glass no more than two or three times
a season. Use a mild glass cleaner to clean the door. Do not use abrasive cleaners. They will damage the glass surface.
PILOT AND BURNER FLAMES
Visually check pilot and burner flames periodically.
See Figure 39
for typical burner flame.
See Figure 40
for typical
pilot flame.
Let glass cool before cleaning. Do not
clean glass when it is hot. Damage
could occur.
CAUTION
Make sure the gas valve knob is in the “OFF” position. Wait at least five (5) minutes before start-
ing maintenance.
VENTING SYSTEM
A qualified agency should examine the venting system annually.
CLEANING GLASS
Make sure that clearances to
combustibles leave enough room for
maintenance and service.
W
ARNING
Carefully reassemble and reseal
insert properly after any cleaning
or servicing.
W
ARNING
FIREBOX CLEANING
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. See pages 20 through 23 .
6. Replace door (if it has been removed).
7. Relight pilot.
See page 28.
8. Turn on main burners.
Figure 39 - Typical Burner Flame
Figure 40 - Typical Pilot Flame
Thermopile
Thermocouple