LEXGO LEX R9, Руководство пользователя, Страница: 8 / 16

8
5. ASSEMBLY AND ADJUSTMENTS
Here's how to assemble the product and open the frame before use:
CONNECT THE HANDLEBARS • Connect the two connectors from the handlebars
and the handlebars
together.
• Carefully insert the excess cable into the column,
being careful to prevent it
from
being crushed or
damaged.
• Slide the handlebars into the column.
• Squeeze the four screws in the tube (see image
next toit).
• Make sure the handlebars are well firm.
FRAME OPENING
Unlo
ck di
sblocco
lever
The frame can be folded and attached to the rear
fender to carry the product easily.
.
On the handlebar there is a hooking system with which
to lock it to the hook on the fender
.
Once closed, to open the frame proceed as explained
below.
• Unlock the hook on the rear fender.
• Lift the handlebars off the platform.
• Lock the lever by lifting it until clicked.
• Place the safety stop in the groove of the lever.
• Perform operations in reverse order to close the
medium.
6. HOW TO START THE SCOOTER
START AND BRAKE
The scooter must be started with the muscle thrust: put one foot on the platform, grab the handlebar
firmly and push the ground with the other foot to get the device moving. To take advantage of the
thrust of the electric motor you need to activate the control panel in advance and reach a minimum
speed of 5 km/h with muscle thrust .
The electric motor's thrust is activated by pushing
Towards The Low The Takes accelerator Inch
(
A ), The Power Delivered From Engine Varies
gradually depending on the rotation Of Takes
accelerator .
To brake the vehicle use the disc brake activated
by the
lever ( B ) . The brake should be used
gently, too sharp a braking can cause imbalance
and falls, with the risk of damage to the driver and
mezzo vehicle.