62
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write.
If your IDE hard drive supports block mode (most new drives do), select Enabled for
automatic detection of the optimal number of block read/writes per sector the drive can support.
The settings are: Disabled, Enabled (default).
PATA DMA Mode
Force IDE device to work in DMA33 or DMA66/100 mode.
Auto
( Default )
By system determine automatically.
DMA33
Work in DMA 33 mode.
DMA66/100
Work in DMA 66/100 mode.
Note: That is supported fastest speed by IDE device to determine in DMA66 or DMA100.
4-7-1 OnChip IDE Device
Phoenix-AwardBIOS CMOS Setup Utility
OnChip IDE Device
Item Help
＊＊＊
On-Chip Serial ATA Setting
＊＊＊
PATA DMA Mode
[ Auto ]
IDE DMA transfer access
Enabled ]
IDE HDD Block Mode
[ Enabled ]
SATA Mode [ IDE ]
LEGACY Mode Support [ Disabled ]
On-Chip Serial ATA [ Enhanced Mode ]
＊＊＊
On-Chip PATA ATA Setting
＊＊＊
On-Chip Primary PCI IDE [ Enabled ]
IDE Primary Master PIO [ Auto ]
IDE Primary Slave PIO [ Auto ]
IDE Primary Master UDMA [ Auto ]
IDE Primary Slave UDMA [ Auto ]
On-Chip Secondary PCI IDE [ Enabled ]
IDE Secondary Master PIO [ Auto ]
IDE Secondary Slave PIO [ Auto ]
IDE Secondary Master UDMA [ Auto ]
IDE Secondary Slave UDMA [ Auto ]
Menu Level >>
↑↓→←
:Move Enter:Select +/
- /PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6: Fail-Safe Defaults F7:Optimized Defaults
[
OnChip Serial SATA
That it has 5 choices as below:
Disabled
Disable SATA Controller.
Combined Mode
PATA and SATA are combined.
Max of 2 IDE drives in each channel.
Enhanced Mode
( default ) Enable both SATA and PATA.
Max of 6 IDE drives are supported.
SATA Only
SATA is operating in legacy mode.
Содержание 3I510AW
Страница 5: ...3 Photo 1 2 1 3 1 2 3 Insert Unplug...
