Lewmar EVO 40, Руководство владельца по установке, эксплуатации и обслуживанию, Страница: 6 / 40

6
OCEAN EVO™
1st 2nd 3rd
68-111 70-90
3.4-4 3.4-3
GB
3. If the motor/gearbox is fitted the opposite way round it will produce the following problems:
• On a single speed winch it will not operate and make a clicking noise. Remove motor/gearbox and refit the
opposite way round.
• On a 2 or 3 speed winch it will dramatically reduce performance. Contact Lewmar for correct fitting of
electrical connections to rectify this situation or refit the motor/gearbox the opposite way round.
4. Correct spindle rotation when fitted and operated.
• Check clearance below deck and accessibility then position the deck switches near and in view of the
winch. Use template as a guide to cut/drill hole, fit switch and seal.
• Once you have selected the ideal position for winch, motor/gearbox and controls, double check everything
and only then drill holes in the deck.
NOTE: Illustrations based on Model 50 Ocean winch unless stated otherwise. For winch models over 65 just
removing the drum gives access to fixing bolt holes.
• Place the winch in position to ensure correct fit once the holes have been drilled/cut.
1. Unscrew the top cap anti-clockwise and remove.
2. OCEAN 40- Remove feeder arm and collets.
OCEAN 46-111- Remove feeder arm.
3. EVO®- Rotate the drum until the cutout in the upper crown is opposite the collets.
3.5 Fitting an electric/hydraulic winch 40-65
⚠ WARNING! Isolate the winch
using circuit breaker/isolator.