Levolor Natural Shades Remote Control, Руководство пользователя

Страница: 132 / 219

Headrail End Marks
Window Opening
2" Space Evenly Space Evenly
Motor
Side
2"
•
Center the brackets on your marks, then mark each of the
screw holes.
— A minimum of 1
1
⁄
4
" flat vertical surface is required to mount
the brackets.
— The top of the installation brackets or extension brackets
should be at the desired shade height. The brackets
should be level and aligned.
— When using extension brackets, mark two screw holes
per bracket.
CAUTION: The rear of the brackets must be flush against a flat mounting
surface. Do not mount brackets on curved molding.
!
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS, CONT.
•
Use a pencil to lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 – 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of
1
⁄
4
in. between the bottom of the installation bracket and the
top of the window molding.
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 1 screw per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional bracket(s)
evenly between the two end brackets, no more than 30" apart, mark drill hole locations.
INSTALLATION
12
Natural Shades Motorized Control Lift