10
Exclusion From A Z-Wave Network
When removing an outlet from a Z-Wave network, best practice is to
use the exclusion command found in the Z-Wave controller.
1. To enter programming mode, hold the button for 7 seconds. The
status light will turn amber, release and the status light will blink.
2. Follow Z-Wave controller directions to enter exclusion mode
3. Tap the button 1 time. The status light will quickly flash green.
4. The Z-Wave controller will remove the device from the network
Factory Default
When removing an outlet from a network it is best practice to use the
exclusion process. In situations where a device needs to be returned
to factory default follow the following steps. A reset should only be
used when a controller is inoperable or missing.
1.
Hold the button for 7 seconds, the
status light will turn amber. Continue
holding the button for another 7
seconds (total of 14 seconds). The
status light will quickly flash red/
amber.
2.
Release the button and the device will
reset.
DR
AF
T
