4
EN
Levenhuk Wezzer Tick H50 Clock-thermometer
The kit includes:
base station, USB cable, user manual, and warranty.
Caution!
Please remember that mains voltage in most European countries is 220–240V. If you want to use your device in a country
with a different mains voltage standard, remember that use of a converter is absolutely necessary.
Getting started
•
Connect the power cable to the device and the DC adapter (not included) via a USB plug and connect to the AC power supply; or
•
Open the battery compartment cover (16) and insert a battery according to the correct polarity. Close the cover.
NOTE!
It is recommended to use an adapter for the continuous operation of the base station, although battery power is also
possible.
Time setting
Press the
SET
button and hold it for 3 seconds. The digits that are to be set are flashing. Press
UP/PROJECT
or
DOWN
to change the
value, and then press
SET
to continue.
The setting order: 12/24h > Hours > Minutes.
Finally, press the
SET
button to save the settings and exit.
Alarm setting
•
Press the
AL
button to set the Alarm 1.
•
In the alarm setting mode press and hold the
AL
button for 3 seconds. The digits that are to be set are flashing. Press the
UP/
PROJECT
button or
DOWN
button to change the value, and then press the
AL
button to continue.
The setting order: Hours > Minutes > Snooze time > Alarm sound. Press the
AL
button to confirm the settings and exit.
•
Repeat the instructions above to set the Alarm 2.
•
To activate or deactivate the Alarm 1 and/or Alarm 2, press the
DOWN
button in normal mode.
The order: AL1 On > AL2 On > AL1 + AL2 On > AL1 + AL2 Off.
•
To silence the alarm, press any button (except the
SNZ/LIGHT
button). The alarm sound will automatically turn off after 2 minutes.
Snooze function
When the alarm sounds, press the
SNZ/LIGHT
button to activate the snooze function. The alarm will sound again in a preset time
span.
Alarm sound
When setting the alarm, you can choose either buzzer (the display shows "bu") or radio (the display shows "rd") as the alarm sound.
Temperature setting
Press the
DOWN
button to switch between °C and °F.
Projection setting
•
Press the
UP/PROJECT
button to turn on the projection, and then press it again to choose the projection brightness (3 levels
available).
•
Press and hold the
UP/PROJECT
button to change the projection degree (0° > 90° > 180°).
Backlight setting
•
Press the
SNZ/LIGHT
button to choose the brightness (4 levels available).
•
Press and hold the
SNZ/LIGHT
button for 3 seconds to turn on/off the Auto mode. The display will automatically lower its
brightness level when it is dark.
Night mode
•
Press the
SET
button, and then press the
UP/PROJECT
button or
DOWN
button to turn on/off the Night mode. The display
brightness will be lowered during a scheduled time span.
