- 3 -
2.Perform Initial Configuration (For model with console port)
1 . C o n n e c t a P C t o t h e s w i t c h c o n s o l e p o r t u s i n g t h e i n c l u d e d c o n s o l e c a b l e .
2. Configure the PC’s serial port: 115200 bps, 8 characters, no parity, one stop bit, 8 data bits, and no flow
control.
3.Log in to the C LI using default settings: U sernam e “adm in” and password “admin.”
3.Logging on to the equipment
1. Connect the RJ-45 interface cable of a switch with a computer using a network cable.
2. Set the TCP/IP properties of the computer, see the
Appendix: Setting up your computer
.
3. Logging on to the equipment: Open a browser and type 192.168.1.1 in the address bar, and then
press Enter; in the pop-up login interface, enter the factory logon
username
"
admin
",
password
"
admin
" and click OK.
Note:
For further information on switch configuration, refer to the
Web Management Guide
and
CLI Reference Guide
.
