Page5
Quick Installation on HVE-6601 :
HVE-6601T Transmitter (Video Wall)
1.
DC5V/PoE:
Connect it to the external AC adapter which plugs into an
electrical outlet. Or via 802.3af PoE PSE to GIGA LAN port.
2.
GIGA LAN:
Connect directly to a Receiver or to a Gigabit IGMP Ethernet
Switch using CAT5e/6 cable.
3.
HDMI IN:
Connect to an HDMI source device via HDMI splitter (optional)
with an HDMI M-M cable.
4.
RS-232:
Used Y Cable to separate S0(RS-232 port) and S1(Debug
console port) for Video Wall system solutions.
P1(DB9P-M): Connect to RS232 port of HVE-6601T.
P2(DB9P-F)(S0): Connect to next HVE-6601T
’s P3(S1) of Y cable.
P3(DB9P-M) (S1): Connect to previous HVE-
6601T’s P2(S0) of Y
cable.
LEDs , button and Group ID setting
1.
POWER LED Blinking:
power on and the unit is booting up.
2.
POWER LED On:
power on and the unit is active.
3.
LINK LED Off:
LAN is not connected.
4.
LINK LED On:
LAN is connected.
5.
DATA LED Blinking:
if Transmitter is connecting with LAN, or the HDMI
source is removed.
6.
DATA LED On:
All the connections are working.
7.
PB :
change Link / Unlink; Engineering Mode and Reset to default using
this button. Please to see the
Push Button Descriptions.
8.
GROUP ID:
Set up the Transmitter’s group ID by adjusting the 4-pin DIP
switch, ON means “1”, OFF means “0”, there are 16 groups available to
set up.
Multicast IP Address
255.0.0.XXX & 255.0.1.XXX, the XXX are resolved by the 4-pin DIP Switch on
the Transmitter.
