Page3
Quick Installation on HVE-6501 :
HVE-6501T Transmitter
1.
DC5V or PoE:
Connect it to the external AC adapter which plugs into an
electrical outlet. Or via 802.3af PoE PSE to GIGA LAN port.
2.
GIGA LAN:
Connect directly to a Receiver or to a Gigabit IGMP Ethernet
Switch using CAT5e/6 cable.
3.
HDMI IN:
Connect to an HDMI source device with an HDMI M-M cable.
Use an HDMI --> DVI adapter if the source is DVI.
LEDs , Button and Group ID setting
1.
POWER LED Blinking:
power on and the unit is booting up.
2.
POWER LED On:
power on and the unit is active.
3.
LINK LED Off:
LAN is not connected.
4.
LINK LED On:
LAN is connected.
5.
DATA LED Blinking:
if Transmitter is connecting with LAN, or the HDMI
source is removed.
6.
DATA LED On:
All the connections are working.
7.
RESET Button:
change Link / Unlink; Engineering Mode and Reset to
default using this button. Please to see the
RESET Button Descriptions.
8.
GROUP ID:
Set up the Transmitter’s group ID by adjusting the 4-pin DIP
switch, ON means “1”, OFF means “0”, there are 16 groups available to
set up.
Multicast IP Address
255.0.0.XXX & 255.0.1.XXX, the XXX are resolved by the 4-pin DIP Switch on
the Transmitter.
