6
Installation and Set-up of LevelOne NAS
Installing the Hardware
Install Hard Drive into FNS-7000
Once you start installing a hard drive into the FNS-7000, you have to obey following
steps:
Power off the FNS-7000.
Release the screws(right & left sides) of drive bay in which the new hard drive will
install.
Make sure the hard driver’s jumpers ”Master/Slave” setting are set to “Cable select”
when you put the new hard drive into the drive tray. Instructions of new hard drive
settings, please refer to the user guide along with the new hard drive.
Attach the power cable from drive tray to your new hard drive.
Attach the IDE connector to the new hard drive.
( please keep around 15~20
˚
between hard drive and drive tray)
Put the screws into the drive tray’s down side to tighten new hard drive.
Chapter 2
