Restoring the factory defaults will erase any previous settings. Reset or
restore the system after power on.
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition
LED color
Loading system after power on
Blink green and orange (twice)
During booting procedure
Non light
Detecting and setting network
Steady orange till IP address is confirmed
After network is setup (system up)
Blink orange and red
During the upgrade firmware process
Rapidly blink orange till firmware is upgraded
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or restore
the factory default settings. Sometimes resetting the system sets the system back to normal
state. If the system problems remain after reset, restore the factory settings and install again.
RESET: Click on the button.
RESTORE:
1. Press on the reset button continuously until the status LED rapidly blinks orange. It takes
about 30 seconds.
2. Upon successful restore, the status LED will blink orange and red.
Содержание FCS-3021
