1. The function module
The function module is equipped with an accurate thermal cut-out. It has a built-in timer with 13
programs, of which 12 are factory set and one is available for user programming.
2. Setting the Day and Time
When first installed, or whenever the panel heater has been disconnected from the mains supply, the Day
and Time will need to be set. To make changes to the LCD module settings the cover has to be removed by
unscrewing the single locking screw
1. Press the timer button 8
2. The current “Day” setting will flash
3. Use the Up 9 and Down 10 buttons to select the correct day
4. Press the timer button 8
5. The current “Hour” setting will flash
6. Use the Up 9 and Down 10 buttons to select the correct hour
7. Press the timer button 8
8. The current “Minute” setting will flash
9. Use the Up 9 and Down 10 buttons to select the correct minute
10. Press the timer button 8
11. The timer setting program will terminate and the selected day and time will be saved.
3. Temperature Selection
The panel heater works with 2 temperature settings: A Low level setting and a high level setting. Each of
these has to be set when the panel heater is installed. The default settings are 17
o
C for the low level and
22
o
C for the high level.
To alter the default settings:
1. Remove the LCD panel cover
2. Press the temperature button 5
3. The high level temperature setting will be displayed
4. Use the Up 9 and Down 10 buttons to select the required temperature. The high level temperature
range is 9
o
C to 30
o
C.
5. Press the temperature button 5
6. The low level temperature setting will be displayed
7. Use the Up 9 and Down 10 buttons to select the required temperature. The low level temperature
range is 5
o
C to 26
o
C.
8. Press the temperature button 5
9. The temperature setting program will terminate and the selected high and low temperatures will
be saved.