2015/12
Specifications
Optical data
Measurement range
1)
1) For objects with a luminosity coefficient of 18 … 90%
5 … 150mm
Edge height
≥
0.1mm
Focus range
100 ± 10mm for
≥
0.1mm edge height
Standard range
10 … 90mm/110 … 140mm for
≥
0.3mm edge height
Threshold
5 … 10mm/140 … 150mm for
≥
0.4mm edge height
Light source
laser, pulsed
Laser class
2 in accordance with IEC 60825-1:2014
Wavelength
670nm (visible red light)
Max. Output power
2)
2) Average value
< 1mW
Pulse duration
3)
3) Typical value
8.3μs
Timing
Counting rate
4)
4) Dependent upon edge height, color and surface structure of the object to be detected.
max. 1000 copies/s
Object speed
≤
7m/s for 0.1mm edge height,
≤
11m/s for
≥
0.4mm edge height
Object sequence distances (overlap flow)
> 1mm
Pulse width adjustment
0.5 … 512ms, fixed pulse width,
adjustable with 270° potentiometer
Dynamic pulse adaptation
12.5 … 50%
Delay before start-up
≤
1.2s
Electrical data
Operating voltage U
B
12 … 30VDC (incl. residual ripple)
Residual ripple
≤
15% of U
B
Open-circuit current
≤
100mA
Switching output
…/4…
pin 4: PNP, activated when edge detected
Signal voltage high/low
≥
(U
B
-2V)/
≤
2V
Output current
max. 30mA
Sensitivity
adjustable, 270° potentiometer
Calibration input CAL
12 … 30VDC
Indicators
Green LED POWER
ready
Yellow LED EDGE
edge detected internally
Yellow LED STATUS
output pulse edge
LED yellow STATUS off/flashing
calibration process in progress/standby mode
LED yellow DPA
dynamic pulse adaptation activated
Mechanical data
Housing
aluminum
Color
black anodized
Optics cover
glass
Fastening
dovetail or
2 M6 screws in place of the profile strip
Weight 690g
Connection type
5-pin M12 connector
Environmental data
Ambient temp. (operation/storage)
-5°C … +55°C / -30°C … +70°C
Protective circuit
5)
5) 1=transient protection, 2=polarity reversal protection, 3= short-circuit protection for transistor output
1, 2, 3
VDE safety class
III
Protection class
IP 54
Standards applied
IEC 60947-5-2
Attention!
It is imperative that the laser safety notices in section 8 are observed
Order guide
Designation
Part No.
Laser edge detector
OPSL 775/4-150-S12
50115063
Tables
Diagrams
0,4
0,3
0,1
110
90
10
5
150
140
0,3
0,4
Mi
nimum edge
height [mm]
Me
asu
remen
t r
ange
[m
m]
Remarks
Function
characteristics:
The OPSL 775 edge detector
is an optoelectronic sensor
for the contactless detection
of object edges.
Operate in accordance with
intended use!
This product is not a safety sensor
and is not intended as personnel
protection.
The product may only be put into
operation by competent persons.
Only use the product in accor-
dance with the intended use.
OPSL 775
