Leuze
electronic
Short instructions IT 6300
Leuze
electronic
Page
7
Resetting the IT 6300 to factory settings
To reset all parameters to factory settings, scan the bar code shown below.
Attention: All settings are lost!!!
Configuration
The hand-held scanner can always be configured using bar codes. To do this, first select the bar code in
the manual and then actuate the trigger button in order to read the code. The configuration is then
immediately accepted and executed.
Several of the most important configurations are listed in the following.
A second option is to configure the hand-held scanner with the USB and RS232 interfaces with the aid of
the "6300 Series Setup Tool" PC program. You can download and install this program from our homepage
at
www.leuze.de
. The program can be used to make settings and transfer them to the hand-held scanner.
The configuration can also be stored so that it can be reused at a later time.
The standard applications are described in the following; each is summarised on a separate page.
