![background image](http://html1.mh-extra.com/html/leuze-electronic/hfu-4500d/hfu-4500d_short-description_1884006009.webp)
Short description HFU 4500D
Leuze
electronic
Page
9
Keys for operation
key
Function
OK
ON/OFF/ACK
Switching Device On / Off, Acknowledge
parameter settings
<7> yellow
pick / select
pick / select menu /function
< > black
arrows
Movement between Menu parts
C
cancel
Cancel / Back
0-9/ABC
Character / No keys
Keys for Data input, first characters
green
Pre select
Pre select code lists (* in display)
With the built in menu structure and the display you can pick and select functions and menu parts to do
Parameter setting or activation of functions. In the upper level after switching ON the functions or the systems
menu are to choose. The device returns automatically after 1min (starting with last pressed key) from the
Systems menu back to the function select (RUN-Mode).
Functions
Function SCAN Barcode
The device reads and decodes 1D / 2D Codes of the released types in a distance up to 350mm after
activation (Press Button) and displays the info. Depending on the setting an output via interface of the code
information is possible, too. 1D / 2D codes are printed typically in ASCII and read so as well. A data output is
possible in HEX-format too, with the suitable parameter. All parameter settings can be found in the sub menus
inside the system area/barcode (see menu structure). The configuration can be done alternatively with the pre
defined codes (see configuration).
Function SCAN RFID
The device reads transponder in distances up to 450mm after activation (Press Button) und displays the Info.
Depending on the setting an output via interface of the information is possible, too. The data is always stored
in hexadecimal format on the transponder. A data output is possible in ASCII-format too, but Data / Serial no.
only. Error messages are shown in the display and (Parameter) possibly transmitted via interface. Up to
32Bytes (depends on tag!) of data (8Blocks) can be read in one operation. All parameter settings can be
found in the sub menus inside the system area/ RFID (see menu structure).
Function EDIT RFID
The device allows you to write data to transponders up to 400mm after input via key board or via telegram
from Host, but always after Activation (Press Button). Parameter dependent an output via interface is
possible. Messages and errors are shown in the display. The max. amount of data for writing is similar to read
max. 32Byte (8Blocks), depends on tag. The input can be (parameter!) either in ASCII or HEX-Format. All
parameter settings can be found in the sub menus inside the system area/RFID (see menu structure).
Function SCAN Barcode and EDIT RFID
This special and unique function reads a released Barcode /2D (3 trials) per activation (Trigger button) and
writes the read information to the next Transponder into the defined memory slot (parameters). Start of Write
op again with trigger button. In any case the device comes back with a message (success/ failure) onto
Display / Interface. The sequence is fixed, an interrupt is only possible with C. All parameter settings can be
found in the sub menus inside the system area/barcode and RFID (see menu structure).