Page 4 of 6
POSITION TWO
POSITION ONE
SAFETY CABLE
STEP 5
The safety cable must be attached to the spine in one of two positions.
POSITION ONE is the recommended position. POSITION TWO will allow the capsule to
slide out an extra five inches if necessary for rear hatch, tailgate or door clearance.
WHEN USING POSITION
TWO,
DO NOT ALLOW
CLAMPS TO OVERLAP
THE 3.5” WARNING
LABEL. DOING SO WILL
PERMIT OVER-EXTENSION
OF THE SAFETY CABLE
ALLOWING THE CAPSULE
TO FALL OFF AND CAUSE
DAMAGE OR PERSONAL
INJURY
NO USE AREA - 3.5” RANGE
WARNING
This position will locate the capsule as close
as possible to the back of the vehicle.
Cable in POSITION ONE. Carrier in Pin
Hole closest to Carrier.
MINIMUM
B
A C K O F V E H I C L
E
CAPSULE
SLIDING TUBE
HITCH PIN
CLAMP
3.50”
SAFE USE ADJUSTABILITY - Minimum Clearance
REQUIRED TOOL: 1/2” WRENCH
