Page 2 of 6
Install the Rear Wheel Stop using two (2)
Steel Nuts and Washers [
C
] and one (1)
U-Bolt [
B
] as shown with the Rear Stop [
A
]
resting on top of the GearCage rails and
the U-Bolt [
B
] secured from underneath as
shown. (Review the bicycle position overview
on Pages 4-5 to confirm placement [Figure 5
& 6].
Hand -tighten only at this time.
NOTE:
The Rear Stop’s “peg” can be
installed and pointed in any of the 6 available
directions, interior, exterior, left & right, top &
bottom.
NOTE:
Like the Fork Mount assembly, the
Rear Wheel Stop can also be “Side Mounted.”
See Figures 3 & 4 on Page 1 for a “Side
Mount” example.
With both the Fork Mount assembly and the Rear Wheel Stop attached, confirm bicycle fit and final placement.
Fully tighten the hardware and secure the Fork Mount assembly and the Rear Wheel Stop to the carrier railing.
NOTE:
The Fork-IT system is for
skewer mount application only
(not for thru axle).
Prepare your bicycle for mounting
by removing the bicycle’s front tire
exposing the “Drop-Outs” (refer to
your Bicycles Manual for proper
tire removal).
Loosen the Tension Nut located
on the Skewer and confirm
the Quick Release Arm is in
the “Open” position [Figure 7].
Lower your bicycles fork onto the
skewer and secure your bicycle
by tightening the Tension Nut and
moving the Quick Release Arm to
the “Closed” position [Figure 8].
Step 2:
Step 3:
Operation:
A
A
B
B
C
BICYCLE FORK
DROP-OUTS
BICYCLE FORK
TENSION
NUT
SKEWER
PEG
[Figure 5]
[Figure 7]
[Figure 6]
[Figure 8]
CLOSED POSITION
QUICK RELEASE
OPEN POSITION
QUICK RELEASE
C
