Page 2 of 4
STEP 2
REQUIRED TOOL: 1/2” WRENCH
U
P
V
Q
N
Set the new Base
[N]
on top of the platform.
Bring each Hat Bracket
[P]
(four total) up from underneath
platform so the Hat Brackets wrap around the tubes of the
platform and align with the holes on the Base
[N]
.
Using two (2) 5/16in Carriage Bolts
[Q]
, two (2) 5/16in Carriage
Washers
[U]
, and two (2) 5/16in Nylock Nuts
[V]
per Hat Bracket
[P]
LOOSELY
connect each Hat Bracket to the Base
[N]
as
shown. [Fg. 2]
Once connected, slide both Bases
[N]
(both the original base
and the new add-on) back and forth along the assembly and
position for desired bicycle clearances. Once positioned,
fully
tighten the hardware on BOTH Bases
[N].
NOTE:
Be sure to avoid positioning the original Base
[N]
over
the warning label located at the platform tubing. See your
original V-Lectric Manual P/N B01892, B01259 or B00390 for
more information
[Fg. 2]
STEP 3:
Using one (1) Wing
[Z]
, slide both foam bumpers to the center of the Wing.
Loosen handles on each Cradle Housing
[AA]
. Slide two (2) Cradle Housings
[AA]
above the foam bumpers and two (2) Cradle Housings below the foam
bumpers.
NOTE:
The Knobs located on each Cradle Housing
[AA] MUST
rest along the
same sides as the connection hole located at the bottom of the Wing. [Fg. 3]
NOTE:
Position the Cradle Housing
so the Knobs alternate direction as shown.
Re-tighten each Cradle Housing
handle to secure in place on the Wing. [Fg. 4]
Repeat this step for the second Wing.
Z
AA
AA
AA
HANDLE
KNOB
KNOB
FOAM
BUMPERS
CONNECTION
HOLE
[Fg. 3]
[Fg. 4]
