THIS RECREATIONAL PRODUCT REQUIRES ADULT SUPERVISION TO ASSEMBLE.
* Unless otherwise specified all instructions will be given assuming the assembler is facing the front opening of the tent.
* Carefully fold out your poles. Make sure each pole segment is “seated” into the next section
before flexing the pole during set-up. Sort poles by type and length; refer to parts list descriptions.
* Do not drop tent pole bag. Do not bounce tent bag on its end to remove tent, as these actions may damage the shock-corded and/or pole ends.
ASSEMBLY INSTRUCTIONS
STEP 1: Verify Package Contents
Tip: Do this at home before you leave on your trip.
STEP 2: Attach Tent Fabric to Trailer
A) Attach Camper Deck Panels to both sides of Trailer.
Place both end gates in center section of trailer.
C)
B)
Open and spread out tent over camper decks and align doors in the right locations.
Start by velcroing each cornor of the decking first.
With the all four corners in place, press down the remaining of the velcro sides.
Extend Fiberglass poles and place in position ready for instllation. Sort by size and
colors.
STEP 3: Install Poles
INSTALL THE OTHER
TWO (2) MAIN TENT POLES
INSTALL FIRST TWO
(2) POLE SETS
A)
Locate th e15ft four Main Tent Poles (uniform in length); install first two (2) pole sets, feed each pole through trnt
sleeves to opposing side of each corner. The other two (2) Main Tent Poles are to be installed starting near the
middle of the tent, feed through tent sleeeve to parallel middle tent pocket. Erect the tent by installing the pole ends
in the corner pockets first and then in the middle pockets.
B)
Apply Velcro Tent Expansion Strips to the front vertical sides of the trailer
TIP: Expansion strips are for optional use to provide added surface area for ease of
doorway zipper use. Strips may remain attached to tent for storage.
