20
10.2 First Operation
1. Open the battery compartment by sliding the door gently downwards (Please see Figure 1).
2. Insert 2 x AAA batteries by following the polarity indications in the compartment. (Please see Figure
1).
3. Plug the application wand into the control unit. (Please see Figure 2).
Use the wand attached to the cable, plug it into the device. Please note that without the headset, only
the wand with the cable will work. We recommend clipping the provided handle into the back of the
wand when not using the headset.
Figure 1 Figure 2
4. Make sure the device is switched off, i.e. the LCD display is OFF. If you accidentally switch the
device on, press and hold the button for 2 seconds to switch it off again.
5. Choose a program as described in the next paragraph and either hold the application device in your
hand or insert it into the headset, depending on the area you want to stimulate.
6. Switch the device ON by pressing the button once. The LCD display will light up and
show the various functions.
7. Use the M button to toggle through the menu:
The device will NOT work unless the sponges in the application wand are wet
and acting as a conductive medium between your skin and the application wand!
In order to remove the belt clip, push the
center area down that is marked with the
triangular arrow to release the lock, and at
the same time pull the clip away from the
unit.