Lester E - Series SCR, Руководство пользователя

Страница: 6 / 20

E-Series
6 of 20 User’s Manual
1. INTRODUCTION
This E-Series battery charger is an advanced, microprocessor-based, silicon-controlled rectifier (SCR) charger
designed to optimize both daily battery capacity and overall battery life. It plugs directly into standard 120V, 15A,
60 Hz AC outlets/receptacles for use in off-board (shelf) or on-board (built-in) applications. The charger is natural
convection cooled with no moving parts. It was factory-configured to charge wet, AGM, or gel deep-cycle lead-
acid batteries, and includes an internal jumper that can be used to select between two battery profiles in the field.
This charger features fully-automatic operation and an ammeter to monitor charge cycle status.
Figure 1-1 provides specifications for the E-Series product line.
Model
Number
DC Output
Volts
DC Output
Amps
Amp-Hour Rating,
C
20
Rate (12 Hrs)
AC Input
Amps
Shipping Weight,
Approx (Lbs)
27070 12 25 150 - 305 5 28
26010 24 21 130 - 225 8.5 34
26040 24 25 150 - 305 9.5 37
25970 36 21 130 - 225 11.5 37
25940 36 25 150 - 305 13.5 39
26070 48 17 105 - 210 11.5 39
Figure 1-1: E-Series Product Line Specifications
2. RECEIVING THE CHARGER
Unpack the charger and examine it for shipping damage. In the event that shipping damage is found, report it as
a claim with the freight company.
3. STORAGE
When the charger is stored prior to being installed and powered up, it must be stored indoors in a clean and dry
environment where the temperatures will remain within the range of -40 °F to 150 °F (-40 °C to 65 °C). The
charger should be stored upright in the shipping carton that it was shipped in. This will help protect the charger
from dust and abrasion. It should be stored in an area where it is not likely to be damaged. Do not stack anything
on top of the charger.
4. BATTERY TYPE
WARNING: DISCONNECT BOTH AC AND DC POWER FROM THE CHARGER BEFORE OPENING THE
CASE. CONTACT WITH LIVE COMPONENTS WITHIN THE CHARGER COULD CAUSE ELECTRICAL
SHOCK, SERIOUS INJURY, OR DEATH.
This charger is designed to charge deep-cycle lead-acid batteries of wet/flooded, AGM (absorbed glass mat), or
gel design. The charger is factory-configured to charge the type of battery indicated in the TYPE field on the
charger ratings label (for example, “Wet”). Additionally, the charger includes a secondary battery profile available
via an internal jumper on the control board. The last four (4) characters in the charger part number, available in
the MODEL field on the charger ratings label, provide the battery profile codes for both the primary and secondary
battery profiles. For example, charger part number 26040A83A1S1W1A1 has a primary battery profile code of
“W1” and a secondary battery profile code of “A1”. Figure 4-1 lists standard battery profile codes and their
corresponding battery profiles. If a battery profile code for your charger is not listed in Figure 4-1, please contact
your dealer regarding which battery profiles are available on your charger.