11
2 Unpacking and assembly
2.3.5 Assembling the extractor
hood / window toggle
- At the hood, fold down the side suction
plates and remove the metal grease filter (fig.
M2a + M2b).
- For installation in the ceiling, lift the hood
up to the ceiling, connect the exhaust duct
firmly to the air vents of the motor box and
the power plug to the power supply, and then
the hood further upwards in the ceiling. Screw
these on now from the inside (fig. M3) through
the lateral plate to the prepared wooden
frames.
CAUTION!
Do not install or operate a defec-
tive extraction hood. Repairs are
performed by specialised personnel
authorised by the manufacturer
( Customer service).
Figure 2: Electronic box
Emergency
switch
Power supply
On/off
Cable
External motor
Electronic box with fine wire fuse