Lenze MCS 09, Инструкции по монтажу и включению

Страница: 7 / 68

Safety instructions
Basic safety instructions
Disregarding the following basic safety instructions and safety information may lead to severe
personal injury and damage to property!
•
Only use the product as directed.
•
Never commission the product in the event of visible damage.
•
Never modify the product technically.
•
Never commission the product before assembly has been completed.
•
Never operate the product without the required covers.
•
Connect/disconnect all pluggable connections only in deenergized condition!
•
Only remove the product from the installation in the deenergized state.
•
The product can – depending on their degree of protection – have live, movable or
rotating parts during or after operation. Surfaces can be hot.
•
Observe all specifications of the corresponding documentation supplied. This is the
condition for safe and trouble-free operation and the achievement of the specified
product features.
•
The procedural notes and circuit details given in the associated documentation are
suggestions and their transferability to the respective application has to be checked. The
manufacturer of the product does not take responsibility for the suitability of the process
and circuit proposals.
•
All work with and on the product may only be carried out by qualified personnel.
IEC 60364 and CENELEC HD 384 define the qualifications of these persons:
-
They are familiar with installing, mounting, commissioning, and operating the product.
-
They have the corresponding qualifications for their work.
-
They know and can apply all regulations for the prevention of accidents, directives, and
laws applicable at the place of use.
Application as directed
•
The product is a professional equipment intended for use by trades, specific professions or
industry and not for sale to the general public. IEC 60050 [IEV 161
‑
05
‑
05]
•
To prevent personal injury and damage to property, higher-level safety and protection
systems must be used!
•
All transport locks must be removed.
•
Mounted eye bolts on the motor are not suitable for transporting geared motors.
•
The product may only be operated under the specified operating conditions and in the
specified mounting positions.
•
The product may only be operated on the inverter.
•
Built-in brakes must not be used as safety brakes.
•
The product must not be operated in private areas, in potentially explosive atmospheres
and in areas with harmful gases, oils, acids and radiation.
Safety instructions
Basic safety instructions
7