Lenze EVS 9300 series, Системное руководство

Страница: 120 / 504

Parameter setting
Parameter setting using the keypad
7-6
l
EDSVS9332S-D11 EN 3.0
7.2.5 Parameter set loading
You can use the keypad to load a saved parameter set into the RAM when the controller is inhibited.
After controller enable the controller uses the new parameters.

Danger!
z
After loading a new parameter set the controller will be initialised again and
behaves as if the mains was switched on:
– System configurations and terminal assignments may be changed. Ensure that
your wiring and drive configuration correspond to the settings of the parameter
set.
z
Only use terminal X5/28 as source for the controller inhibit! Otherwise, the drive
can start in an uncontrolled way when changing to another parameter set.

Note!
z
After connecting the supply voltage the controller always loads parameter set 1
into the RAM.
z
You can also load other parameter sets into the RAM via the digital inputs or bus
commands.
Step Keys Action
1. Inhibit controller Terminal X5/28 = LOW
2. Load saved parameter set into the RAM
A)     Select code C0002 ”PAR LOAD in the menu ”Load/Store”
B)

Change to parameter level
Display ”0” and ”Load Default”
If you want to return to the state as delivered, proceed with D)
Select parameter set to be loaded C)  Load parameter set 1:
Ö
Set ”1” ”Load PS1”
Load parameter set 2:
Ö
Set ”2” ”Load PS2”
Load parameter set 3:
Ö Set ”3” ”Load PS3”
Load parameter set 4:
Ö Set ”4” ”Load PS4”
D)   ”RDY” is off. The parameter set has been completely loaded into the RAM when
”RDY” is on again.
3.
Change to the code level
A)  Display of operation level
B)  Display C0002 ”PAR LOAD”
4. Enable the controller. Terminal X5/28 = HIGH
The drive is now running with the settings of the loaded parameter set