Commissioning
Establish Ethernet connection
Configure Ethernet interface
7
33
LDCDS−EL100 EN 8.0
7.3
Establish Ethernet connection
The EL 1xx can be connected to a LAN or to a PC directly (peer−to−peer) via Ethernet
interface.
7.3.1
Configure Ethernet interface
Prerequisite:
ƒ
The EL 1xx is physically connected to the fieldbus via Ethernet interface.
– Network (with router): via Ethernet cable
– Peer−to−peer (without router): via crossed Ethernet cable (cross−over)
ƒ
The EL 1xx is switched−on.
How to proceed:
1. Click
Start
®
Settings
®
Network and Dial−up Connections
on your EL 1xx.
2. Click the
Dm9CE1
connection and configure the following dialogue via network
interface.
EL100−021
3. Click
OK
.
Note!
Modifications are not stored automatically in the Registry. This means that
they will be lost after a restart.
If you wish to make permanent modifications, proceed as follows:
ƒ
Click
Start
®
Settings
®
Control Panel
®
Registry
on your EL 1xx.
ƒ
Click
Save
.
4. If an IP address assignment via DHCP Server was specified when configuring the
interface (only available for networks with router), restart the EL 1xx.
5. Double−click the network symbol down right in the status bar and check the
settings.
