LF101XF function decoder
2
2
Important safety instructions
The function decoder LF101XF is to be used only with Lenz
DIGITAL plus or other standard digital controls with an NMRA-
conformance seal. If in doubt, ask the system supplier.
The maximum current-carrying capacity of the decoder outputs
must not be exceeded as this will destroy the decoder! The parts
of the decoder must not be allowed to touch the metal
components of the chassis or the body of the locomotive as this
will cause a short-circuit within the decoder resulting in its
destruction.
Never wrap the decoder in insulating tape
as this
prevents the
necessary air circulation around the decoder. Instead, use
insulating tape or something similar around the metal
components of the vehicle to avoid unintentional short-circuits
without depriving the decoder of air. Use double-sided adhesive
tape to affix the decoder.
Technical data:
Total current-carrying capacity:
0.4 A
Current-carrying capacity of the outputs: 200 mA each
Settable locomotive addresses:
1 - 9999
By default, the decoder is set as follows
(Of course, these default settings can be changed as desired):
Locomotive address: 3
Speed-step mode: 28 steps
Outputs A and B: controlled by F0, polarity-dependent
Output C: controlled by Function 3
Output D: controlled by Function 4
Output E: controlled by Function 5
Output F: controlled by Function 6
