Lenz Elektronik Digital Plus, Руководство пользователя

Страница: 8 / 13

Silver Direct Locomotive decoder 8
8
Table of supported CVs
CV Meaning Range
Factory
setting
1 Basic locomotive address. This number is the short address
used to control the locomotive. When writing this CV, CV19
(consist address) is automatically cleared and CV29 Bit 6
(use of extended address) is deleted is set to 0. 1-127 3
2 Minimum starting voltage
0-255 0
3 Starting delay
0-255 6
4
Braking delay 0-255 5
5 Maximum speed 0-255 255
6 Mid speed Vmid (a value of 60 will give a linear curve) 0-255 48
7 Version number - 78
8 Manufacturer’s ID - 99
9 Back EMF Repetition Rate
0-63 15
17
Extended locomotive address, high-order byte 192-231 192
18
Extended locomotive address, low-order byte 0-255 100
19 Consist address 1-99 0
29 Decoder Configuration, Byte 1: 6 (dec)
bit 0
(1)
Locomotive direction of travel:
0 = locomotive’s direction is normal
1 = locomotive’s direction is reversed 0,1
[1]
0
bit 1
(2)
Headlight mode:
0 = Operation with 14 or 27 speed step systems..
1 = Operation with 28, 55 or 128 speed steps.
Note: your system must be set to the same mode. 0,1
[2]
1
bit 2
(3)
Usage on conventional DC layouts:
0 = locomotive operates in digital mode only
1 = locomotive can operate on either conventional DC
and on DCC 0,1
[4]
1
bit 3
(4)
Not Used
0 0
bit 4
(5)
Speed Curve Selection:
0 = factory pre-set speed curve is used
1 = user defined speed curve is used. Please enter the
appropriate values into CV 67 to 94 before setting this
bit. 0,1
[16]
0
bit 5
(6)
Extended Addressing
0= Normal addressing
1= Four digit extended addressing 0-1
[32]
0
bit 6 bit 7 always 0 0 0