Lenovo ThinkSystem ST550, Руководство по установке

Страница: 84 / 136

Step 2. Lower the new backplate into the chassis and insert the new backplate into the backplate slot.
Then, carefully push the new backplate inward until it is secured by the release tab.
Figure 44. Simple-swap-drive backplate installation
Step 3. Connect the cables on the backplate to the system board. See “Server models with eight 3.5-inch
simple-swap drives” on page 33.
Install a backplane
Use this information to install a hot-swap drive backplane.
Note: This section applies only to server models that support hot-swap-drive backplanes.
This section contains the following information:
• “Install the backplane for eight 2.5-inch hot-swap drives” on page 80
• “Install the backplane for four 3.5-inch hot-swap drives” on page 81
Install the backplane for eight 2.5-inch hot-swap drives
Use this information to install the backplane for eight 2.5-inch hot-swap drives.
“ Read the
installation
Guidelines” on
page 58
“ Power off
the server for
this task” on
page 109
“ ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 59
Before installing the backplane for eight 2.5-inch hot-swap drives, touch the static-protective package that
contains the new backplane to any unpainted surface on the outside of the server. Then, take the new
backplane out of the package and place it on a static-protective surface.
To install the backplane for eight 2.5-inch hot-swap drives, complete the following steps:
Watch the procedure . A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku: http://list.youku.com/albumlist/show/id_50483452
Step 1. Note the orientation of the new backplane.
80
ThinkSystem ST550 Setup Guide