Lenovo ThinkSystem D3284, Руководство по установке и обслуживанию оборудования

Страница: 59 / 159

Installation checklist 59
3 Installation
Installation checklist
This chapter shows how to plan for and successfully install your enclosure system into an industry standard 19-inch
rack cabinet. Test File.
CAUTION: To install the system, use only the power cords supplied, or power cables that match the
specification quoted in “AC power cords” (page 151) .
The following table outlines the steps required to install the enclosures, and initially configure and provision the
storage system. To ensure successful installation, perform the tasks in the order presented.
1-The environment in which the enclosure operates must be dust-free to ensure adequate airflow.
2-For more information about hosts, see the About hosts topic in the Storage Manager Guide.
Table 9 Installation checklist
Step Task Where to find procedure
1 Unpack the enclosure See “Unpacking the enclosure” (page 61) .
2 Install the controller enclosure and optional
drive enclosures in the rack. 1
See “Required tools” (page 63) .
See “Requirements for rackmount installation” (page 63) .
See “Installing the 2U enclosure” (page 63) .
See “Installing the 5U enclosure” (page 64) .
3 5U84 enclosure only: populate drawers with
disks (DDIC–disk in drive carrier)
2U enclosures ship with disks installed.
See “FDE considerations” (page 66) .
See “Accessing drawers” (page 133) .
See “Populating drawers with DDICs” (page 57) .
See “Installing a DDIC” (page 137) .
4 Connect the controller enclosure and
optional expansion enclosures.
See “Connecting the controller enclosure and optional
expansion enclosures” (page 66)
5 Connect power cords. See “Power cord connection” (page 71) .
6 Test enclosure connectivity. See “Testing enclosure connections” (page 71) .
7 Install required host software. See “Host system requirements” (page 72) .
8 Connect hosts. 2 See “Host system requirements” (page 72) .
9 Connect remote management hosts. See “Connecting a management host on the network”
(page 79) .
10 Obtain IP values and set network port IP
properties on the controller enclosure.
See “New user setup” (page 80) .
For USB CLI port and cable see USB device connection .
11 For CNC models, verify the host interface
protocol setting (not necessary for SAS
models).
See “CNC technology” (page 73) , The CNC IOMs allow for
setting the host interface protocol for qualified SFP options.
See “Change the CNC port mode” (page 86) .
12 Perform initial configuration tasks: 3
•
Sign-in to the web-browser interface to
access the application GUI.
• Verify firmware revisions and update if
necessary.
•
Initially configure and provision the
system using the SMC.
Topics below correspond to bullets at left:
See the “Getting Started” chapter in Storage Manager Guide.
See
“Updating firmware” (page 79) . Also see the same topic
in the Storage Manager Guide.
See the topics about configuring the system and provisioning
the system in the Storage Manager Guide.