Lenovo Thinkpad X230s, Руководство по техническому обслуживанию аппаратной части

Страница: 60 / 100

180 degrees more
(Cross-section)
Notes:
• Ensure that you use the correct screw. It is recommended to use new screws for replacements. If you
have a torque screwdriver, tighten all screws firmly to the torque specified in the screw information
table for each step.
• Ensure that torque screwdrivers are calibrated correctly following country specifications.
Retaining serial numbers
This topic provides instructions on the following:
•
“Restoring the serial number of the system unit” on page 54
• “Retaining the UUID” on page 55
• “Reading or writing the ECA information” on page 55
Restoring the serial number of the system unit
When the computer was manufactured, the EEPROM on the system board was loaded with the serial
numbers of the system and all major components. These numbers need to remain the same throughout
the life of the computer.
If you replace the system board, you must restore the serial number of the system unit to its original value.
Before replacing the system board, save the original serial number by doing the following:
1. Install the latest version of LENOVO ThinkPad Hardware Maintenance Diskette or Maintenance Key,
and then restart the computer.
2. From the main menu, select 1. Set System Identification .
3. Turn off the computer, and then turn on the computer again.
4. When the ThinkPad logo is displayed, press Esc.
5. Select 2. Read S/N data from EEPROM and follow the instructions on the screen. The serial number of
each device in your computer is displayed; the serial number of the system unit is listed as follows:
• 20 Serial number
6. Write down that number.
Note: The serial number of the system unit is also written on the label attached to the bottom of the computer.
After you have replaced the system board, restore the serial number by doing the following:
1. Install the latest version of LENOVO ThinkPad Hardware Maintenance Diskette or Maintenance Key,
and then restart the computer.
2. From the main menu, select 1. Set System Identification .
3. Turn off the computer, and then turn on the computer again.
4. When the ThinkPad logo is displayed, press Esc.
5. Select 1. Add S/N data from EEPROM . Follow the instructions on the screen.
If the MTM and Product ID numbers differ from each other on the rear label, use what is shown for the
Product ID field.
54
Hardware Maintenance Manual