Lenovo Thinkpad X230s, Руководство по техническому обслуживанию аппаратной части

Страница: 39 / 100

Power-on password
A power-on password protects the system from being powered on by an unauthorized person. The
password must be entered before an operating system can be started.
To remove the power-on password, do the following:
• If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer.
2. Remove the built-in battery packs. For instructions on how to remove the battery pack, see “1020
Front battery” on page 60.
3. Remove the backup battery. For instructions on how to remove the backup battery, see “1090
Backup battery” on page 69. Wait for a few seconds.
4. Reinstall the backup battery. For instructions on how to install the backup battery, see “1090 Backup
battery” on page 69.
5. Reinstall the built-in battery packs. For instructions on how to install the battery pack, see “1020
Front battery” on page 60.
6. Turn on the computer and wait until the POST ends. After the POST ends, the password prompt
does not appear. The power-on password has been removed.
• If a supervisor password has been set and is known to the service technician, do the following to remove
the power-on password:
1. Turn on the computer.
2. When the logo screen is displayed, immediately press F1. Type the supervisor password to enter
the ThinkPad Setup program.
3. Select Security .
4. Select Password .
5. Select Power-On Password .
6. Type the current supervisor password in the Enter Current Password field. Then leave the Enter
New Password field blank, and press Enter twice.
7. In the Changes have been saved window, press Enter.
8. Press F10 to save changes and exit the ThinkPad Setup program.
Hard disk password
There are two kinds of hard disk passwords:
• User hard disk password - for the user
• Master hard disk password - for the system administrator, who can use it to get access to the hard disk
even if the user has changed the user hard disk password
Note: There are two modes for the hard disk password: User only and User . The User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If it has, it can be used for access to the hard disk drive. If no master hard disk password is
available, neither Lenovo nor Lenovo authorized service technicians provide any services to reset either
the user or the master hard disk password, or to recover data from the hard disk drive. To put the system
back to operational status, the only Lenovo and Lenovo-authorized service solution would be to replace the
hard disk drive with a scheduled fee.
Chapter 4
.
Related service information
33