Lenovo ThinkCentre M90p, Руководство по обслуживанию, Страница: 99 / 112

Figure 32. Removing the system fan
8. Align the four tabs on the bottom of the new system fan with the corresponding holes in the chassis,
and push the new system fan straight down until it snaps into position.
9. Connect the system fan cable to the microprocessor fan connector on the system board. See “Locating
parts on the system board” on page 70.
10. To reinstall the front bezel, align the three tabs on the front bezel with the corresponding holes in the
chassis and pivot the front bezel inwards until it snaps into position.
11. Go to “Completing the parts replacement” on page 93.
Completing the parts replacement
After completing the installation or replacement for all parts, you need to close the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 “Using the Setup Utility program” on page 39.
To close the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See “Locating components” on page 69 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it. To reinstall the front bezel, align the three tabs on
the front bezel with the corresponding holes in the chassis and pivot the front bezel inwards until
it snaps into position.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
Chapter 8
.
Replacing FRUs (Machine type: 7536)
93