Lenovo ThinkCentre 8129, Руководство пользователя, Страница: 39 / 62

4. If necessary, see “Installing adapters” on page 14 to remove any adapters that
impede access to the Clear CMOS/Recovery jumper.
5.
Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
6. Replace the cover and connect the power cord. See “Replacing the cover and
connecting the cables.”
7. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
8. Repeat steps 2 through 4 on page 22..
9. Move the jumper back to the standard (pins 1 and 2).
10.
Replace the cover and connect the power cord. See “Replacing the cover and
connecting the cables.”
Replacing the cover and connecting the cables
After working with options, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the option that is installed, you might need to confirm the updated
information in the Setup Utility program.
To replace the cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer.
2.
Lower the drive bay assembly.
3. Clear any cables that might impede the replacement of the cover.
4.
Position the cover over the chassis and pivot it down over the computer until it
snaps into place.
5.
Reconnect the external cables and power cords to the computer. See “Installing
external options” on page 6.
6. To update the configuration, see Chapter 2, “Using the Setup Utility program,”
on page 25.
Chapter 1. Installing options
23